3000m wireless remote control switch Radio Switch 12V 1 channel Remote Access Control

Package Include:
1* Receiver
1* Remote Control (with battery)

Feature
High sensitivity:RXB8 module, sensitivity -114dBm, sensitivity and anti-jamming capability are far beyond super-renewable and ordinary superheterodyne modules on the supermarket, and the remote control distance is farther and more stable.
Relay Output: This receiver is dry relay output, it can be used to operate both DC and AC equipments. The output terminals are NO / NC (normally open / normally closed), which serves as a switch.
Small size: small size, circuit board size is only 35*32*19mm, suitable for various modifications.
Wireless control, easy to install. Wireless RF signal can pass through walls, floors, doors or windows. You can use two or more units in the same place.
You can turn on/ off the receiver with transmitter (remote control) from any place within a reliable distance.
Reliable control: The receiver only works with the transmitter which use same code. One/several transmitters can control one/several receivers simultaneously.

Working Range(actual Test distance: 2360M without obstacles in open space)
With a transmitter to form a complete set, the maximum working distance can reach 3000M in an open ground.
The maximum working distance is a theoretical data, it shall be operated in an open ground, no barriers, no any interference. But in the practice, it will be hindered by trees, walls or other constructions, and will be interfered by other wireless signals. Therefore, the actual distance may not reach this maximum working distance.

Parameters:
Working voltage: DC12V / 24V
Working frequency: 315MHZ
Contact capacity: ≤10A/250VAC; 10A/30VDC
Receive sensitivity: >-114dB
Control Modes: Self-locking, Momentary, Interlocking
Maximum Working Current: 10A / each channel
Operating Temperature: -20 ° C to +70 ° C
Uses: garage doors, motorcycles, car alarm products, home security products, wireless remote control products, industrial control products.

Control mode
Momentary------------Press the Transmitter button A, the receiver relay A is ON, release button A; the receiver relay A is OFF,
Toggle---------------Press transmitter button A for 1 time , the receiver relay A is ON, press button A again, the receiver relay A is OFF,
Latched------------Press transmitter button A, the receiver relay A is ON, Press transmitter button B, the relay A OFF.

Set the different control modes:
Toggle: Jumper on "T-PIN" + Middle PIN
Momentary: Jumper on "M-PIN" + Middle PIN
Latch: without jumper

Learn method: Turn on the power, Receiver light will light for 3 seconds, After it is extinguished, press the learning button briefly. The indicator light is on. Press the remote control button immediately. The indicator light will turn off. Learn success

Clear code:Turn on the power, Receiver light will light for 3 seconds, After light extinguishing, press and hold the learning button of the receiver. The indicator light is on. After 8 seconds, the indicator light flashes three times and goes out. The clear code is successful.